Transformer Buchholz Relay: Operating Principle, Functions and Setting Calculations
A Buchholz relay is a gas and liquid actuated relay used to protect conservator-type liquid-immersed transformers and reactors. It is installed in the pipe connecting the transformer main tank to the conservator. In accordance with IEC terminology, a Buchholz relay is intended to detect: Gas release from the protected equipment; Liquid surge from the main […]
2026-09-13
Read more →
Transformer Overcurrent Protection Relays: Operating Principle and ANSI 50/51 Setting Calculations
Transformer overcurrent protection relays continuously monitor transformer currents through current transformers (CTs). When the measured current exceeds the configured pickup setting and the relevant operating conditions are satisfied, the relay sends a trip command to the circuit-breaker to clear the fault. For small and medium-sized distribution transformers, overcurrent protection may serve as the main protection. […]
2026-09-13
Read more →
Transformer Protection Systems: Protection Functions, Typical Configurations and Relay Selection
Transformers are critical assets in power plants, substations, renewable-energy installations and industrial power-distribution systems. Winding short circuits, earth faults, overexcitation, overloading, mechanical faults and abnormal non-electrical conditions can damage the transformer, interrupt the power supply and, in severe cases, cause a fire. A transformer protection system monitors electrical quantities and non-electrical conditions, including current, voltage, […]
2026-09-12
Read more →
MNS vs GCS Low-Voltage Withdrawable Switchgear: Similarities and Differences
1. Similarities They belong to the same product category. Both are types of low-voltage switchgear and controlgear assemblies that incorporate withdrawable functional units, typically used in 380/400/415 V AC distribution systems. They provide similar primary functions. Both can incorporate incoming units, outgoing feeder units, bus-coupler units, motor-control units and reactive power compensation units. They can […]
2026-09-11
Read more →
Where Are ANSI 50/51 Overcurrent Protection Relays Used?
1. What Is ANSI 50/51 Overcurrent Protection? An overcurrent protection relay continuously measures the current flowing through a power circuit. When the measured current exceeds the configured pickup value and the applicable operating criteria are satisfied, the relay issues a trip command to the circuit breaker. This isolates the faulty equipment or circuit section and […]
2026-09-09
Read more →
What Is the Difference Between a Substation Protection Panel and a Control and Monitoring Panel?
1. Key Difference Protection panels and control and monitoring panels are both essential components of a substation secondary system, but they perform different functions: A protection panel detects electrical faults and initiates fault clearance, while a control and monitoring panel acquires operating data and controls primary equipment. In simple terms, the protection panel safeguards primary […]
2026-09-09
Read more →
Line Differential Protection (87L) Setting Calculations
Line current differential protection (ANSI 87L) settings should be based on the relay algorithm, line charging current, CT performance and power-system short-circuit calculation results. The following settings are expressed in per-unit values based on the relay rated current\( I_{\mathrm{n}} \)and apply to protection relays with a rated current input of 1 A or 5 A. […]
2026-09-01
Read more →
Line Current Differential Protection (ANSI 87L): Functions, Protection Zone and Applications
The ANSI/IEEE device function number for line current differential protection is 87L. Its operating principle is based on comparing the currents measured at all line terminals and determining whether a fault is internal by calculating the difference between the currents entering and leaving the protected zone. Hereinafter, it is referred to as “line current differential […]
2026-08-31
Read more →
